Highlights
  • Support one SATA and one IDE (ATA/ATAPI) devices.
Introduction

U2-PSATA03S is a USB 2.0 to ATA/SATA bridge board.

U2-PSATA03S is ideally suited for tailgate interface applications for two ATA/SATA devices. It allows ATA/SATA drives (Master and Slave) to be connected to USB 2.0 serial bus in a plug-and-play fashion.

U2-PSATA03S provides the perfect solution for data backup and transferring of data between computers using ATA/SATA drives.
Technical Specifications

USB 2.0 to ATA/SATA Bridge Board:

  • DC Power Connector: with mini 4-pin Floppy Disk Drive power connector
  • IDE (ATA) Interface: Male IDC 2X20 Connector
  • Both ATA and ATAPI devices are supported using the same firmware.
  • Complies with T13's ATA/ATAPI-6 Draft Specification:
    • PIO Mode 0 ~ 4
    • Multi-Word DMA Mode 0 ~ 2
    • Ultra DMA Mode 0 ~ 5
  • Supports 48-bit addressing for large hard drives (>128GB)
  • Complies with Gen1i and Gen1m of Serial ATA II Electronic Specification 1.0
  • Serial ATA port: One Signal Plug Type (7pin) Connectors
  • Serial ATA Bus Transfer Rate: 1.5 Gbps
  • Supports hot-plug & hot-swap feature of Serial ATA to USB.
  • USB 2.0 Interface: One USB B-Type connector
  • USB Bus Transfer Rate: High Speed (480 Mbit) And Full Speed (12 Mbit)
  • USB Bus Power: Self Powered Mode Operation
  • Power indicator LED and ATA/SATA Access LED
  • SCSI I 50pin Low Density Centronics Connector Form Factor
    (Fit to most standard SCSI enclosure)
Physical Dimensions
  • 2.97" x 1.34" (7.54cm x 3.40cm)
Net Weight
  • 35.3g
Hardware Requirement
  • Desktop PC: with either a built-in USB (1.0 or 2.0) controller or an USB (1.0 or 2.0) to PCI Host Adapter equipped with a external USB port.
  • Laptop PC: with either a built-in USB (1.0 or 2.0) controller or an USB (1.0 or 2.0) to CardBus PC Card equipped with a external USB port.
Operating System Requirements
  • Windows 98SE/ME/2000/XP/2003; MacOS 9.1 or higher; Linux
  • Driver Requirements
    • USB:
      • No driver installation for Windows ME, 2000, XP, 2003, Mac OS and Linux.
      • Driver available for Window 98 SE
Applications
  • Application 1: With R14 installed (Default)
    One IDE (ATA/ATAPI) and one SATA drives
    Note:
        - Supports SATA hot- plug feature.
        - Do not support two IDE (ATA/ATAPI) drives.
     
     
    Application 2: Without R14 installed
    Option 1: Two IDE (ATA/ATAPI) drives
    Option 2: One IDE (ATA/ATAPI) and one SATA drives
    Note:
        - Do not support SATA hot- plug feature.
        - Since the blue color IDC connector do not have pin34 so please use black -to- black type IDE cable.
Kit includes
  • Kit 1:
    • U2-PSATA03S Bridge Board
    • CB-00072--- Y-Shape DC Power Cable (Red, Black, Black, Yellow) with three power connectors
      one FDD like mini 4pin, one IDE big 4pin male plug and one IDE big 4pin female plug
    • CD-tilte (Driver for Windows 98/98SE, Backup Software)
  • Kit 2:
    • U2-PSATA03S Bridge Board
    • CB-00072--- Y-Shape DC Power Cable (Red, Black, Black, Yellow) with three power connectors
      one FDD like mini 4pin, one IDE big 4pin male plug and one IDE big 4pin female plug
    • CB-00279 -- Ultra DMA100 Cable 12 inch (Black to Black).
    • CD-tilte (Driver for Windows 98/98SE, Backup Software)
  • Kit 3:
    • U2-PSATA03S Bridge Board
    • CB-00072--- Y-Shape DC Power Cable (Red, Black, Black, Yellow) with three power connectors
      one FDD like mini 4pin, one IDE big 4pin male plug and one IDE big 4pin female plug
    • CB-00279 (CB-000083) -- Ultra DMA100 Cable 12 inch (Black to Black).
    • CB-00175 (CB-U00025)--- A Plug -to- B Plug USB 2.0 cable in length of 1.0m
    • CD-tilte (Driver for Windows 98/98SE, Backup Software)
  • Kit 4:
    • U2-PSATA03S Bridge Board
    • CB-00072--- Y-Shape DC Power Cable (Red, Black, Black, Yellow) with three power connectors
      one FDD like mini 4pin, one IDE big 4pin male plug and one IDE big 4pin female plug
    • CB-00279 (CB-000083) -- Ultra DMA100 Cable 12 inch (Black to Black).
    • CB-00175 (CB-U00025) --- A Plug -to- B Plug USB 2.0 cable in length of 1.0m
    • CB-00280 (CB-S00010)--- SATA 7pin Plug to SATA 7pin Plug cable in length of 50cm.
    • CD-tilte (Driver for Windows 98/98SE, Backup Software)
  • Kit 5:
    • U2-PSATA03S Bridge Board
    • CB-00072--- Y-Shape DC Power Cable (Red, Black, Black, Yellow) with three power connectors
      one FDD like mini 4pin, one IDE big 4pin male plug and one IDE big 4pin female plug
    • CB-00279 (CB-000083)-- Ultra DMA100 Cable 12 inch (Black to Black)
    • CB-00175 (CB-U00025)--- A Plug -to- B Plug USB 2.0 cable in length of 1.0m
    • CB-00280 --- SATA 7pin Plug to SATA 7pin Plug cable in length of 50cm.
    • CB-00194 (CB-S00002) --- SATA 15pin female -to- IDE big 4pin male power connector cable in length of 15cm
    • CD-tilte (Driver for Windows 98/98SE, Backup Software)
  • Kit 6:
    • U2-PSATA03S Bridge Board
    • CB-00072--- Y-Shape DC Power Cable (Red, Black, Black, Yellow) with three power connectors
      one FDD like mini 4pin, one IDE big 4pin male plug and one IDE big 4pin female plug
    • CB-00292 (CB-000090) -- Ultra DMA100 Cable 12+6 inch for two devices (Black - Gray - Black)
    • CB-00280 --- SATA 7pin Plug to SATA 7pin Plug cable in length of 50cm.
    • CB-00194 --- SATA 15pin female -to- IDE big 4pin male power connector cable in length of 15cm
    • CB-00175 --- A Plug -to- B Plug USB 2.0 cable in length of 1.0m
    • CD-tilte (Driver for Windows 98/98SE, Backup Software)