• U2EIDE01P support two IDE (ATA/ATAPI) devices.

U2EIDE01P is a USB 2.0 to ATAPI Bridge Board

It is ideally suitable for tailgating removable-media devices such as CD-ROM, CD-R, CD-RW, DVD-ROM, DVD-RAM, tape drive, and hard disk drive. It allows IDE drive (master or slave) to connect to USB 2.0 serial bus in a plug-and-play fashion.

Both ATA and ATAPI devices are supported with the same firmware.

USB 2.0 to IDE (ATA/ATAPI) Bridge Board: Cypress CY7C68300C

• USB 2.0 interface: one USB B-type connector
• USB bus transfer rate: high speed (480 Mbit) or full speed (12 Mbit)
• USB-IF Certified Compliant for USB 2.0 (Test ID Number: 40490119)
• USB bus power: self-powered mode operation
• Complies with T13's ATA/ATAPI-6 draft specification
  • PIO mode 0, 3, 4
  • Multiword DMA Mode 2 
  • Ultra DMA mode 2, 3, 4
  • Supports 48-bit addressing for large hard drives (>128GB).
• IDE (ATA/ATAPI) Interface: Male IDC 2X20 Connector
• The IDE (ATA/ATAPI) port supports multi-LUN function for attaching two (Master and Slave) IDE devices.
• Both ATA and ATAPI devices are supported using the same firmware.
• Power indicator LED and HDD Access LED
• PCI Bracket Form Factor (Fit to most standard PC Case)

• Self Access
  Connect U2EIDE01P to the resident PC's USB port through a USB cable.

• Share
  Connect U2EIDE01P to the other PC's USB port through a USB cable.

• Desktop PC: with either a built-in USB (1.0 or 2.0) controller or an USB (1.0 or 2.0) to PCI Host Adapter equipped with a external USB port.
• Laptop PC: with either a built-in USB (1.0 or 2.0) controller or an USB (1.0 or 2.0) to CardBus PC Card equipped with a external USB port.

• Windows 98SE/ME/2000/XP/2003; MacOS 9.1 or higher; Linux
• Driver Requirements
  • USB:
    • No driver installation for Windows ME, 2000, XP, 2003, Mac OS and Linux.
    • Driver available for Window 98 SE

• U2EIDE01P Bridge Board
• Y-shape DC power cable
• A-to-B type USB 2.0 cable (1.0 m length)