The UF2PSATA01 is a high performance combo bridge solution for connecting USB 2.0 and 1394 to ATA/ATAPI or SATA data storage devices, e.g. hard disk drives, CD-ROM, CD-R, CD-RW and DVD.

The USB interface of UF2PSATA01 supports USB 1.1 or USB 2.0 specifications to allow connections to host computer via USB port at maximum data transfer rate 480 Mbps.

The 1394 interface of the UF2PSATA01 is in compliant with IEEE Std 1394-1995 and IEEE P1394a specification supporting data transfer rate 100, 200 and 400 Mbps, and built-in SBP2 (Serial Bus Protocol 2) hardware engine to enhance sustained data transfer rate up to 40 MBytes/sec.

UF2PSATA01 provides a switch which allow user to set the function for Read-only (Write Protect) or Read/Write.

• Provides hot-swap function to select active device USB or 1394
• Provides auto-detect function to select active device between USB and 1394
• IEEE 1394-1995 and IEEE P1394a Compliant
• Universal Serial Bus Specification 1.1 and 2.0 Compliant
• USB Mass Storage Class Bulk-Only Transport Specification Compliant.
  No driver installation needed in Windows ME or above, Mac OS 9.x or above, and Linux (kernel 2.4.18 or above).
  Windows 98 requires additional driver installation provided by Prolific.
• AT Attachment with Packet Interface Extension (ATA/ATAPI-7) Compliant
  • ATA interface support PIO mode 0~4
  • Multiword DMA mode 0~2
  • Ultra-DMA mode 0~4
• Built-in hardware automated SBP2 protocol engine for 1394 connection which includes:
  • Management ORB fetch engine
  • Command ORB fetch engine
  • Page table fetch engine
  • Response packet generate engine
• FireWire and i.LINK 1394 Compliant Logo (TA ID #200404004)
• USB-IF Hi-Speed Logo Certified (TID No. 40002614)
  

USB 2.0 & FireWire (IEEE 1394a) to ATA or SATA Bridge Board:

• USB 2.0 interface: One USB B-type connector
• USB bus transfer rate: high speed (480 Mbit) or full speed (12 Mbit)
• 1394a PHY: Ti's TSB41AB2
• 1394 Bus Transfer Rate: 100/200/400 Mbps
• FireWire (IEEE 1394a): Two FireWire-6pin Connectors
• Complies with T13's ATA/ATAPI-6 Draft Specification:
  • Multiword DMA Mode 0 ~ 2
  • Ultra-DMA mode 0~4
  • Supports 48-bit addressing for large hard drives (>128GB)
• IDE (ATA) Interface: IDC 2X20 Male Connector
• Both ATA and ATAPI devices are supported using the same firmware.
• Complies with Serial ATA Generation 1 (1.5Gbps)
• Serial ATA Interface: Signal Latch Type (7pin) Connector
• Provide Three Indicator LEDs:
  • Write Protect LED (Red Color)
  • Power LED (Green Color)
  • Activity LED (Green Color)
• Self Powered Mode Operation
• DC Power Input: mini 4-pin (+12V, GND, GND, +5V) FDD like Power Connector

• 9.3cm (W) x 6.3cm (L) x 2.8cm (H)

• Desktop PC:
  With either a built-in FireWire (IEEE 1394) controller or a FireWire (IEEE 1394) to PCI Host Adapter equipped with a external FireWire (IEEE 1394) port.
• Desktop PC:
  With either a built-in USB (1.0 or 2.0) controller or an USB (1.0 or 2.0) to PCI Host Adapter equipped with a external USB port.
• Laptop PC:
  With either a built-in FireWire (IEEE-1394) controller or a FireWire (IEEE 1394) to CardBus PC Card equipped with a external FireWire (IEEE 1394) port.
• Laptop PC:
  With either a built-in USB (1.0 or 2.0) controller or an USB (1.0 or 2.0) to CardBus PC Card equipped with a external USB port.
  

• Windows 98SE/ME/2000/XP/2003/Vista/7; MacOS 9.1 or higher; Linux
• Driver Requirements
  • FireWire:
    • No driver installation for Windows 98SE, ME, 2000, XP, 2003, Vista, 7, Mac OS and Linux
  • USB:
    • No driver installation for Windows ME, 2000, XP, 2003, Vista, 7, Mac OS and Linux.
    • Driver available for Window 98 SE

• UF2PSATA01 Bridge Board
• CB-00054--- FireWire 6pin to 6pin Cable (1.0m length)
• CB-00398---FireWire 6pin to 4pin Cable (2.0m lemgth)
• CB-00257---USB A to B Type Cable (1.0m length)
• CB-00334---SATA 7pin to 7pin Latch Cable (0.5m length)
• CB-00279---Ultra DMA66 Cable
• CB-00355---M-Shape DC Power Cable (Red, Black, Black, Yellow) with power connectors (one FDD like mini 4pin, one SATA 15pin power plug and two IDE big 4pin female plug).
• User's Guide
• DCS2-1205A DC Power Kit
  • DCS2-1205 Power Switch
  • M-Shape DC Power Cable (Red, Black, Black, Yellow) with power connectors (one FDD like mini 4pin, one SATA 15pin power plug and two IDE big 4pin female plug).
  • AC to DC Power Adapter
    • DCS2-1205A : 34W (12V/2A, 5V/2A) AC to DC power adapter.
      • AC 100 ~ 240 V to DC +5V/2A and +12V/2A Power Adapter
      • Input: Full Range 100 ~ 240 V, 1.2A, 50 ~ 60Hz
      • Output: DC +5V/2A and +12V/2A
      • Power Max. 34 Watt
      • Safety: UL/CSA/TUV/BS
  • AC power cord (Length: 6 feet)
  • User's Guide