Features
  • Provides hot-swap function to select active device USB or 1394
  • Provides auto-detect function to select active device between USB and 1394
  • IEEE 1394-1995 and IEEE P1394a Compliant
  • Universal Serial Bus Specification 1.1 and 2.0 Compliant
  • USB Mass Storage Class Bulk-Only Transport Specification Compliant.
    No driver installation needed in Windows ME or above, Mac OS 9.x or above, and Linux
    (kernel 2.4.18 or above).
    Windows 98 requires additional driver installation provided by Prolific.
  • AT Attachment with Packet Interface Extension (ATA/ATAPI-7) Compliant
    • ATA interface support PIO mode 0~4
    • Multiword DMA mode 0~2
    • Ultra-DMA mode 0~4
  • Built-in hardware automated SBP2 protocol engine for 1394 connection which includes:
    • Management ORB fetch engine
    • Command ORB fetch engine
    • Page table fetch engine
    • Response packet generate engine
  • FireWire and i.LINK 1394 Compliant Logo (TA ID #200404004)
  • USB-IF Hi-Speed Logo Certified (TID No. 40002614)
Introduction

The UF2PSATA22 is a high performance combo bridge solution for connecting USB 2.0 and 1394 to ATA/ATAPI or SATA data storage devices, e.g. hard disk drives, CD-ROM, CD-R, CD-RW and DVD.

The USB interface of UF2PSATA22 supports USB 1.1 or USB 2.0 specifications to allow connections to host computer via USB port at maximum data transfer rate 480 Mbps.

The 1394 interface of the UF2PSATA22 is in compliant with IEEE Std 1394-1995 and IEEE P1394a specification supporting data transfer rate 100, 200 and 400 Mbps, and built-in SBP2 (Serial Bus Protocol 2) hardware engine to
enhance sustained data transfer rate up to 40 MBytes/sec.

UF2PSATA22 provides a switch which allow user to set the function for Read-only (Write Protect) or Read/Write.

UF2PSATA22 could be installed into the 3.5" Floppy Disk Drive bay of the computer case.
You also can use it as an external bridge solution.
Technical Specifications
Front I/O
  • One USB B-Type Connector
  • One FireWire(IEEE 1394a) 6pin Connector
  • One iLink(IEEE 1394a) 4pin Connector
  • One Big 4-pin IDE Power Connector
  • Write Protect Function Switch
  • LED
    • Write Protect LED (Red Color)
Rear I/O
  • One IDC 2X20 Male Connector
  • One SATA Signal Latch Type (7pin) Connector
  • One Mini 4-pin FDD like Power Connector
  • LEDs
    • Power LED (Red Color)
    • Activity LED (Green Color)
1394 Bus Transfer Rate 100/200/400 Mbps
USB Bus Transfer Rate High Speed (480 Mbit) and Full Speed (12 Mbit)
SATA Transfer Rate SATA (1.5 Gbit/sec)
ATA/ATAPI-7 Compliant
  • ATA interface support PIO mode 0~4
  • Multiword DMA mode 0~2
  • Ultra-DMA mode 0~4
Power
  • DC input
    • Big 4-pin(+12V, GND, GND, +5V) IDE Power Connector
  • DC Output
    • Mini 4-pin (+12V, GND, GND, +5V) FDD like Power Connector

 
Applications
  • Application A: UF2PSATA22 could be an External Bridge

  • Application B: UF2PSATA22 is designed to fit the dimension of 3.5" Floppy Disk Drive bay of the computer case.
Physical Dimensions
  • 100.8mm (W) x90mm (L) x 25.4mm (H)
  • 3.5" FDD Form Factor
Operating System Requirements
  • Windows 98SE/ME/2000/XP/2003/Vista/7; Mac OS 9.1 or higher; Linux
  • Driver Requirements
    • FireWire:
      • No driver installation for Windows 98SE, ME, 2000, XP, 2003, Vista, 7, Mac OS and Linux
    • USB:
      • No driver installation for Windows ME, 2000, XP, 2003, Vista, 7, Mac OS and Linux.
      • Driver available for Window 98 SE
Kit includes
  • UF2PSATA22 Bridge Board
  • CB-00058 FireWire plug to iLink plug Cable (Length=1.0 meter)
  • CB-00175 A plug to B plug USB 2.0 Cable  (Length=1.0 meter)
  • CB-00334 SATA 7pin plug to SATA 7pin plug Cable with Latch on both ends (Length=0.5 meter)
  • CB-00251 Ultra DMA100 Cable (Length=18 inch, Blue to Black)
  • CB-00442 M-Shape DC Power Cable (Red, Black, Black, Yellow) with power connectors (one FDD like mini 4pin, one SATA 15pin power plug and two IDE big 4pin female plug)
  • PK-MA152 User's Guide