Introduction

IDE-SATA07 is a Parallel ATA to Serial ATA Host mode Bridge Board featuring Marvell 88SA8052 Serial ATA bridge Controller.

IDE-SATA07 is ideally suited for tailgate interface applications for converting Serial ATA device into ATA device. Both ATA and ATAPI modes are supported using the same firmware.

Technical Specifications

Parallel ATA to Serial ATA Bridge Board:

  • Serial ATA:
    • Compliant with Serial ATA 1.0
    • 48-bit sector addressing
  • Serial ATA Connector:
    • Signal + Power (7+15 pin) Female Type Connector
  • Parallel ATA:
    • Ultra ATA/133 Parallel Interface
    • 48-bit sector addressing
    • Jumper for selecting Master and Slave
  • Parallel ATA Connector:
    • Male IDC 2X20 pin Connector
  • Transfer Rate:
    • Supports PIO and DMA modes
    • Supports bus master DMA at 1.5Gbps burst rate
  • DC Power Connector:
    • IDE Big 4-pin power connector
  • LEDs
    • Power LED
    • SATA PHY Ready LED
    • Activity LED (Pin Header 2pin Pitch=2.54mm)
Application
For 5.25" ODD
For 3.5" HDD
Physical Dimensions
  • 2.3 " x 1.00" (5.85cm x 2.54cm)
  • Direct Connect Vertical type
Kit includes
  • IDE-SATA07 Bridge Board
Packing list
Packing Type
Q'ty/Carton
Carton size
G.W.
Remark
Bulk Packing
200pcs
CT-00008 58*44*23cm
5.5kg
 
*G.W. tolerance ±0.5kg