Highlights
  • SATA-IDE03-HF support one SATA device.
Introduction

SATA-IDE03-HF is a Parallel ATA to Serial ATA Host mode Bridge Board featuring Marvell 88SA8040 Serial ATA bridge Controller. SATA-IDE03-HF is ideally suited for tailgate interface applications for converting Parallel ATA Host to Serial ATA host. Both ATA and ATAPI modes are supported using the same firmware. It allows SATA drive to be connected to ATA host controller. SATA-IDE03-HF provides the perfect solution for legacy ATA host controller to attach new SATA devices.

Technical Specifications

Parallel ATA to Serial ATA Bridge Board :

  • Serial ATA:
    • Compliant with Serial ATA 1.0
    • 48-bit sector addressing
  • Serial ATA Connector:
    • Signal 7pin Latch Type Connector
  • Parallel ATA:
    • Ultra ATA/133 Parallel Interface
    • 48-bit sector addressing
    • Jumper for selecting Mater and Slave
  • Parallel ATA Connector:
    • Female IDC 2X20 pin Connector
  • Transfer Rate:
    • Supports PIO and DMA modes
    • Supports bus master DMA at 1.5Gbps burst rate
  • DC Power Connector:
    • Mini 4-pin floppy type power connector (SATA-IDE03-HFS, SATA-IDE03-HFR) or JST compatible wafer 2pin (pitch=2.5mm) connector  (SATA-IDE03-HFS1, SATA-IDE03-HFR1)
Available Models

SATA-IDE03-HFS

SATA-IDE03-HFS1

 

SATA-IDE03-HFR

SATA-IDE03-HFR1

Physical Dimensions
  • 6.00cm x 3.20cm
Applications

For Mainboard

Vertical Installation
Horizontal Installation

 
Kit includes
  • SATA-IDE03-HF Bridge Board
  • CB-00072--- Y-Shape DC Power Cable (Red, Black, Black, Yellow) with three power connectors
    one FDD like mini 4pin, one IDE big 4pin male plug and one IDE big 4pin female plug (Only for SATA-IDE03-HFS/SATA-IDE03-HFR)
  • Manual