Highlights
  • IDE-SATA08 support two devices.
Introduction

IDE-SATA08 is a Parallel ATA to Serial ATA Host mode Bridge Board featuring Marvell 88SA8052 Serial ATA bridge Controller. IDE-SATA08 is ideally suited for tailgate interface applications for converting Parallel ATA Host to Serial ATA host. Both ATA and ATAPI modes are supported using the same firmware. It allows SATA drive to be connected to ATA host controller. IDE-SATA08 provides the perfect solution for legacy ATA host controller to attach new SATA devices.

Technical Specifications

Parallel ATA to Serial ATA Bridge Board :

  • Serial ATA:
    • Compliant with Serial ATA 1.0
    • 48-bit sector addressing
  • Serial ATA Connector:
    • Signal 7pin Latch Type Connector
  • Parallel ATA:
    • Ultra ATA/133 Parallel Interface
    • 48-bit sector addressing
    • Jumper for selecting Mater and Slave
  • Parallel ATA Connector:
    • Female IDC 2X20 pin Connector
    • Male IDC 2X20 Connector
  • Transfer Rate:
    • Supports PIO and DMA modes
    • Supports bus master DMA at 1.5Gbps burst rate
  • DC Power Connector:
    • Mini 4-pin floppy type power connector
Available Models
IDE-SATA08-RR
IDE-SATA08-SS
IDE-SATA08-RS

 
Physical Dimensions
  • 6.00cm x 3.20cm
Applications

For Mainboard:

Vertical Installation
IDE-SATA08-RR
Horizontal Installation
IDE-SATA08-SS

For Devices:

  • One SATA and one PATA
    IDE-SATA08-RR
Kit includes
  • IDE-SATA08 Bridge Board
  • CB-00072--- Y-Shape DC Power Cable (Red, Black, Black, Yellow) with three power connectors
    one FDD like mini 4pin, one IDE big 4pin male plug and one IDE big 4pin female plug