• It’s fully compatible with all kinds of slim SATA ODDs
• Provides Jumper for selecting Master and Slave

IDE-SATAPI01 is a Parallel ATA to Slim SATA Host mode Bridge Board.

IDE-SATAPI01 is ideally suited for tailgate interface applications for converting Slim SATA ODD. It’s fully compatible with all kinds of slim SATA ODDs, like CD-ROM, DVD-ROM, CD-RW and DVD-RW drives.

Parallel ATA to Slim SATA Bridge Board:

• Serial ATA:
  • Compliant with Serial ATA 1.0
  • 48-bit sector addressing
• Slim SATA Connector:
  • Slimline SATA 7+6 pin Female Type Connector
• Parallel ATA:
  • Ultra ATA/133 Parallel Interface
  • 48-bit sector addressing
  • Jumper for selecting Master and Slave
• Parallel ATA Connector:
  • Male IDC 2X20 pin Connector
• Transfer Rate:
  • Supports PIO and DMA modes
  • Supports bus master DMA at 1.5Gbps burst rate
• DC Power Connector:
  • JST compatible wafer 2pin (pitch=2.5mm) connector

• With the same height as Slim SATA ODD
• 101.5mm x 12.7mm
• Direct Connect Vertical type

• IDE-SATAPI01 Bridge Board
• JST compatible wafer 2pin to IDE Big 4pin Power Cable (CB-00504)
• Two Screws (SC-00066)
• Two Spacers (CO-M0303)
• User's Manual