Highlights
  • Host Bus: PCI Express base 2.0 specifications
  • PCI low-profile form factor
  • Supports two 6 Gbps SATA ports and one PATA port
  • With IDE Firmware
Introduction

The S3-PCIE1XG201-I is a SATA III (6 Gbps) and PATA to PCI Express x1 Gen2 Host Card.

The S3-PCIE1XG201-I provides both SATA and ATA/ATAPI functions. It supplies two 6 Gbps SATA ports and one PATA port.

The S3-PCIE1XG201-I brings a high-performance 3 or 6 Gbps SATA and PATA hardware RAID solution to desktop/consumer storage applications utilizing a 1-lane PCI Express 2.0 interface. The S3-PCIE1XG201-I supports devices compliant with the Serial ATA International Organization: Serial ATA Revision 3.0 specification and the ATA/ATAPI-7 specification.

S3-PCIE1XG201-I supports a high reliable and extremely fast variety of storage applications (RAID 0, 1 and JBOD).

Technical Specifications

PCIe Host Bus

  • PCI Express 2.0 endpoint device
  • Compliant with PCI Express 2.0 specifications
  • Supports communication speed of 2.5 Gbps and 5.0 Gbps
  • Supports IDE programming interface registers for the SATA controller and the ATA/ATAPI controller.
  • Supports aggressive power management
  • Supports error reporting, recovery and correction
  • Supports Message Signaled Interrupt (MSI)

SATA Features

  • Compliant with Serial ATA Specification 3.0
  • Supports communication speeds of 6.0 Gbps, 3.0 Gbps, and 1.5 Gbps
  • Supports programmable transmitter signal levels
  • Supports Gen 1i, Gen 1x, Gen 2i, Gen 2m, Gen 2x, and Gen 3i
  • Supports ATA and ATAPI commands
  • Supports two SATA Ports
  • Supports Native Command Queuing (NCQ)
  • Supports Port Multiplier FIS based switching or command based switching
  • Only supports one SATA Port multiplier
  • Supports Partial and Slumber Power Management states

PATA Features

  • Supports ATA/ATAPI-7 specification, supports ATA and ATAPI commands
  • Supports DMA protocols, and up to UDMA 150 MBps data transfer rate
  • Supports Multiword DMA and PIO modes for data transfer
  • Supports Master and Slave operations from a single port
  • Supports IDE programming interface
Number of Ports:
  • Two SATA Ports
  • One PATA Port
Computer Platform
  • Computer with PCI Express slot (x1, x4, x8, x16)

    Note:
    For the best performance (5.0 Gbps), S3-PCIE1XG201-I should be installed in a PCIe Gen 2 compliant slot in the host computer.  Most computers have PCIe Gen 2 (5.0 Gbps) throughput on x8 or x16 slots.
    A PCIe Gen 1 compliant slot reaches up to 2.5 Gbps throughput.

Operating System Requirements

S3-PCIE1XG201-I (IDE mode)

Native drivers (Standard Dual Channel PCI IDE Controller) supported in the following operating systems

  • Windows 2000/ XP/ Server2003
  • Windows Vista/ 7
Certifications
  • CE Test: Pass
  • FCC Test : Pass
  • VCCI Test: Pass

      

Optional Accessories
  • Low Profile PCI Bracket (BR-00226-01)