Primary PCI Express |
- Standards Compliant
- PCI Express Base Specification, r3.0 (compatible w/ PCIe r1.0a/1.1 & 2.0)
- PCI Power Management Spec r1.2
- Microsoft Windows Logo Compliant
- Supports Access Control Services
- Dynamic link-width control
- Dynamic SerDes Speed Control
- High Performance
- performancePAK
- Multicast
- Dynamic Buffer/FC Credit Pool
- Non-blocking switch fabric
- Full line rate on all ports
- Cut-Thru packet latency of less than 100ns between symmetric (x4 to x4) ingress and egress Ports
- 2KB Max Payload Size
- Quality of Service (QoS)
- Traffic Class Queuing
- Eight Traffic Classes per port
- Weighted round-robin source port arbitration
|
USB Features |
- One Channel support two ports of USB 3.1
- Up to USB 3.1 Gen 2 10Gbps
- Compliant with Universal Serial Bus 3.1 Specification Revision 1.0
- Compliant with Universal Serial Bus Specification Revision 2.0
- Compliant with USB Attached SCSI Protocol Revision 1.0
- Support Multiple INs function
- Support USB 3.1 and USB 2.0 Link Power Management
- Support Control, Bulk, Stream, Interrupt, Isochronous transfer type
- Support independent port power control
- Support overcurrent detection
- Integrate Spread Spectrum Controller for USB 3.2 interface
- Backward compatible with Legacy USB function and device
- Support the Debugport
|
USB Data Transfer Rate |
- USB 3.1 Gen 2 (10Gbps), USB 3.1 Gen 1 (5Gbps), USB 2.0 (480MB)
|
Number of Ports |
Eight independent USB 3 Cable Ports
- Right A-type Receptacle, USB IF TID 360000055
- The Vbus of each USB Port has a 2.0A Single Channel Current-Limited Power Switch for protection
(IC-S0371-03H)
- 2.0A (70mΩ on-resistance) Single Channel Current-limited Power Switch
- UL File Number E322375
|
USB Bus Power Input |
12V Step-Down to 5V from either PCIe 12V or Power Connector 12V (ATA 4-pin or SATA 15-pin)
The USB Bus power (5V) are step-down from 12V and the
12V input might from either PCIe Edge Connector or
Auxiliary Power Connectors (J1 & J2).
Note:
If the PCIe Slot can’t supply 12V current high enough then you have to
attach the Auxiliary Power from either J1 (ATA 4-pin) or J2 (SATA 15-pin). |