Primary PCI Express |
- Standards compliant
- PCI Express Base Specification r3.0 (compatible with PCIe r1.0a/1.1 & 2.0)
- PCI Power Management Spec r1.2
- Microsoft Windows Logo Compliant
- Supports Access Control Services
- Dynamic Link-width control
- Dynamic SerDes speed control
- High Performance
- Non-Blocking switch fabric
- Full line rate on all Ports
- Cut-Thru with 154ns max packet latency
- 2KB max payload size
- PCI Express Power Management
- Link power management states: L0, L0s, L1, L2/L3 Ready, and L3
- Device states: D0 and D3hot
- Quality of Service (QoS) support
- Traffic Class Queuing
- Eight Traffic Classes per Port
- Weighted Round-Robin source port arbitration
|
Secondary PCI Express |
- Support PCI Express Gen2x2 or Gen3x1
- Up to 10Gbps bandwidth performance with low latency
- Support PCI Express Link power management
- Compliant with PCI Express Base 3.0 Specification
- Compliant with PCI Express card Electromechanical 2.0 specification
- Compliant with PCI Express Mini Card Electromechanical 1.2 specification
- Compliant with Express Card Standard Revision 2.0
- Compliant with PCI Bus Power Management Interface Specification Revision 1.2
- Compliant with PCI Local Bus Specification Revision 3.0
- Support overclocking capability on PCI Express interface
|
USB Features |
- One Channel support two ports of USB 3.1
- Up to USB 3.1 Gen 2 10Gbps
- Compliant with Universal Serial Bus 3.1 Specification Revision 1.0
- Compliant with Universal Serial Bus Specification Revision 2.0
- Compliant with USB Attached SCSI Protocol Revision 1.0
- Support Multiple INs function
- Support USB 3.1 and USB 2.0 Link Power Management
- Support Control, Bulk, Stream, Interrupt, Isochronous transfer type
- Support independent port power control
- Support overcurrent detection
- Integrate Spread Spectrum Controller for USB 3.1 interface
- Backward compatible with Legacy USB function and device
- Support the Debugport
|
USB Data Transfer Rate |
- USB 3.1 Gen 2 (10G), USB 3.1 Gen 1 (5G), USB 2.0 (480MB)
|
Number of Ports |
Four independent USB 3 Cable Ports
(Type-C Receptacle)
|
USB Bus Power Input |
12V Step-Down to 5V from either PCIe 12V or Power Connector 12V (J1: ATA 4-pin or J2: SATA 15-pin)
The USB Bus power (5V) are step-down from 12V and the 12V input might from either PCIe Edge Connector or Auxiliary Power Connectors (J1 & J2).
Note:
If the PCIe Slot can’t supply 12V current high enough then you have to attach the Auxiliary Power from either J1 (ATA 4-pin) or J2 (SATA 15-pin). |