HU3S114 provides three downstream USB ports, and one SATA port.
It is ideally suited for tailgate interface applications for one SATA device.
It allows SATA drive to be connected to USB 2.0 serial bus in a plug-and-play fashion.
HU3S114 provides a cost-effective solution for system integrator to integrate one SATA drive into their system through the USB 2.0 serial bus.

HU3S114SH combines two key components:
1). Four ports USB 2.0 High Speed Hub
2). USB 2.0 to SATA Bridge Board

1). Four ports USB 2.0 High Speed Hub:

HU3S114SH provides four downstream USB ports, with Multiple Transaction Translator (MTT) for all ports, making it the most cost effective hub solution.

The HU3S114SH works backward compatible either when any one of downstream ports are connected to an USB 1.1 compliant device, or when the upstream port is connected to a USB 1.1 compliant host.

• Compliant with USB 2.0(Data Rate 1.5/12/480Mbps)
• 4 downstream ports
  • Three downstream ports (USB2&3&4) are USB A Type. (Right angle USB A receptacle connector)
  • One downstream port for USB 2.0 to SATA Bridge
• Upstream port
  • USB B-Type connector
• Multiple Transaction translator (MTT)
  • MTT provides respective TT control logics for each downstream port.
• All downstream facing ports can handle high-speed (480 Mbps), full-speed (12 Mbps), and low-speed (1.5 Mbps) transaction.
• Supports Over-current detection and Individual power control
• Self-powered mode operation.
• DC Power Connector
  • Floppy Disk Drive like mini 4-pin DC power connector

2). USB 2.0 to SATA Bridge Board:

• Serial ATA port: Signal (7pin) type connector
• Serial ATA Bus Transfer Rate: 1.5 Gbps
• Supports hot-plug & hot-swap feature of Serial ATA to USB.
• USB Bus Transfer Rate: High Speed (480 Mbit) And Full Speed (12 Mbit)
• Self-powered mode operation.
• Complies with Gen1i and Gen1m of Serial ATA II Electronic Specification 1.0
• Power indicator LED and SATA Access LED

• 8.90cm (W) x 1.97cm (H) x 6.94cm(D)
• Form Factor
  • SCSI I 50pin Low Density Centronics Connector Form Factor
  • Fit to most standard SCSI enclosure.

Kit 1:

• HU3S114S Bridge Board
• CB-00072 --- Y-Shape DC Power Cable (Red, Black, Black, Yellow) with three power connectors
• User's Guide

Kit 2:

• HU3S114S Bridge Board
• CB-00072 --- Y-Shape DC Power Cable (Red, Black, Black, Yellow) with three power connectors
• One CB-00334 --- SATA plug with latch to SATA plug with latch Signal Cable in length of 50cm
• User's Guide

Kit 3:

• HU3S114S Bridge Board
• CB-00072 --- Y-Shape DC Power Cable (Red, Black, Black, Yellow) with three power connectors
• One CB-00334 --- SATA plug with latch to SATA plug with latch Signal Cable in length of 50cm
• CB-00136 - A Plug -to- B Plug USB 2.0 cable in length of 1.5m
• User's Guide