Introduction
IDE-SATAMT01 is a Parallel ATA to Serial ATA mobile tray for the following IDE mobile rack.
  • FW-i345MR, FW-142AMR, U2-IDEMR02, KTCIDEMR and IOIIDEMR.

Inside the IDE-SATAMT01 there is a Parallel ATA to Serial ATA Host mode Bridge Board featuring Marvell 88SA8040 Serial ATA bridge Controller.
It allows SATA drive to be connected to ATA host controller. IDE-SATAMT01 provides the perfect solution for legacy ATA IDE mobile rack to attach new SATA HDDs.
Available Models
Image Color Model No.
Beige IDE-SATAMT01a
Black IDE-SATAMT01b
Technical Specifications

Parallel ATA to Serial ATA Bridge Board:

  • Serial ATA:
    • Compliant with Serial ATA 1.0
    • 48-bit sector addressing
  • Serial ATA Connector:
    • Signal + Power Female Type Connector
  • Parallel ATA:
    • Ultra ATA/133 Parallel Interface
    • 48-bit sector addressing
    • Jumper for selecting Mater and Slave
  • Parallel ATA Connector:
    • Male IDC 2X20 pin Connector
  • Transfer Rate:
    • Supports PIO and DMA modes
    • Supports bus master DMA at 1.5Gbps burst rate

Mobile Tray:

  • The IDE-SATAMT01 HDD tray provides SATA connector (7+15 pin) for connecting 3.5" and 2.5" SATA HDD.

  • The HDD tray was made by aluminum which is good for heat dissipation.
  • Ejecting pull handle with miniature keylock.

  • Power indicator LED and HDD Access LED